3qt. Resin & Hardener $111.90

Currently Out of Inventory

1.5Gal Resin & Hardener $169.90

Currently Out of Inventory

 

3Gal Resin & Hardener $299.85

Currently Out of Inventory

SilverTip Epoxy
SilverTip Laminating Resin is a medium-low viscosity epoxy system that has been optimized for coating and reinforcing fabric saturation in wood-composite
Boatbuilding.  It has superior wet-out characteristics with little tendency to foam or trap air.  Both the resin and hardener are nearly colorless and are used in an easy 2:1 ratio.  The working time is longer than most boat building epoxies without sacrificing cure time. We offer this as an option in our boat kits. (Temperatures: Slow Silvertip = warmer than 65°F, Fast Silvertip = cooler than 65°F)

Please note: this item can ship via UPS ground service only. It is not eligible for shipments to Alaska or shipping via mail.

 

Currently out of stock

 

Plunger pump set screws onto System Three epoxy containers and delivers 1 oz. per stroke for resin and a 1/2 oz. for hardener (with restrictor in). Pump fits gallon, quart, and pint containers. These are the same pumps that are included in our kits. The pair includes a 'restrictor' to reduce, by half, the volume of the hardener.

Currently Out of Inventory

1/8" thick "nap" no-lint foam rollers, for laminating fiberglass with epoxy. 7" length. Note: Thicker foam rollers can leave bubbles in your epoxy! Only use 1/8" foam rollers.

cCurrently out of stock

• These frames work with the foam roller covers. The roller covers can be cut in half and used with the 3 inch frame for smaller jobs or tight places.
  

$4.00 7-Inch

$2.50 3-Inch

 

Currently Out of Inventory

An excellent adhesive & sealant for hatch foam and knee brace installation. 3.7 ounce tube. Please note: this item can ship via UPS ground service only. It is not eligible for shipments to Alaska or shipping via mail.

Currently out of stock

System Three Spar Urethane Varnish is a high-solids finish designed for marine use.  The varnish contains ultraviolet light absorbers, which offer excellent protection from sun, salt air and water.  A solo kayak requires 1 quart (approximately 3 coats).Please note: this item can ship via UPS ground service only. It is not eligible for shipments to Alaska or shipping via mail.

 

 

Currently out of stock

 

System Three's Water reducible linear polyurethane rivals solvent-based coatings in durability and weatherability.  It contains ultraviolet light absorbers for maximum life in the sun.  Harder to apply by hand than varnish, but when sprayed yields excellent results.  Includes cross linker. A solo kayak requires 1 quart (approximately 3 coats).

Please note: this item can ship via UPS only. It is not eligible to ship via mail.

Currently Out of Inventory  

Flagship Varnish combines superior gloss retention and the highest ultra violet protection available.  It can be built up to many coats for a deep, rich mirror-like finish.  A solo kayak requires 1 quart (approximately 3 coats).
Please note: this item can ship via UPS ground service only. It is not eligible for shipments to Alaska or shipping via mail.

   

Currently out of stock

Captain’s Varnish 1015 is highly regarded for its ease of application, outstanding gloss retention and tough yet flexible durability. A combination of phenolic and alkyd resins blended with tung and linseed oils provide excellent performance. It’s warm, light amber hue will enhance the rich, classic bright work appearance. 

Please note: this item can ship via UPS ground service only. It is not eligible for shipments to Alaska or shipping via mail

 

Currently out of stock

.

SeaFin Teak Oil is a penetrating oil that dries to a low sheen to seal and protect interior and exterior woods from moisture and weathering. It creates a durable, non-slip surface to repel water and resist wear. Recommended for maintaining and refinshing the NorthPoint Greenland paddles. Learn more about maintaining your NorthPoint paddle here.

Please note: this item can ship via UPS ground service only. It is not eligible for shipments to Alaska or shipping via mail.

Currently Out of Inventory  

Z Spar / Pettit T-10 120 medium brushing thinner is designed for spraying in hot weather and brushing in most conditions. This is a general purpose thinner used in most paint products for ease of application when brushing.. 
Please note: this item can ship via UPS ground service only. It is not eligible for shipments to Alaska or shipping via mail.

 

Currently Out of Inventory

Drip Rings
Drip rings keep water from your paddle blade blade off of your lap.  All of our paddles include drip rings.  We carry these for people who wish to make their own paddles.

 Currently out of stock

By Sandvik of Sweden. A tempered steel edge tool, handy for removing drips from partially cured epoxy. Size 6" x 2.5"

Currently out of stock  

Used to inject epoxy into seams. Please note that each kit comes with 3 syringes. Cleaning Note: if you immediately plunge/clean your syringes with acetone after use, you can re-use these many times.  Keep the acetone sealed in a small glass jar and re-use many times.

Currently out of stock

 

Work Cleanly!  Wear Gloves!

currently not available

Currently Out of Inventory

1Qt bag.  Wood flour is used to thicken epoxy for fillets, bonding, and seam filling. (included in kits)

 

Currently out of stock

Keepers Footbraces
These footbraces are standard with our kits.  Includes two 15" rails, two foot pads and mounting hardware.

Currently out of stock

 

 

Conte nt

Six ounce 38" wide plain weave "E" glass.  Specifically treated for use with epoxy resins, wets out crystal clear. To order multiple yards simply increase the quantity in the shipping cart.

Currently out of stock

nPackage includes 10 aluminum head steel push pins. Each kit includes these push pins so it is not necessary to order this with a kit.

Currently Out of Inventory